Jewelry Box #2: Tarting up

20161009_215704

An empty box is as boring as batsh*t, so the next stage of this project was to make and install some dividers to break up the inside of the box. This meant planing down some thin maple panels, cutting notches in them so that they lock together in a criss-cross formation, and then cutting some housing dados in the side of the box. Continue reading “Jewelry Box #2: Tarting up”

Advertisements

Jewelry Box #1: Inlaid dovetails

20160916_154730

It has been a long old while since I have posted on this blog. Up until a few weeks ago, I had oodles of time in the workshop because I only worked in the evenings. Shortly after I finished my workbench however, I took on a new job during the day. This has meant that my workshop time has been drastically reduced. I’ve still managed to put in some hours here and there, so I thought I’d fire off a series of posts over the next few days, to show off a project that I have recently completed. Continue reading “Jewelry Box #1: Inlaid dovetails”